Address
Form of work****This is onsite work, no remote option*****
Electro Mechanical Packaging Design Engineer
Min Requirements:
Electro Mechanical Packaging Design Engineer
Min Requirements:
- Experience in 3D CAD software NX11 and (Teamcenter preferred)
- Experience in the design of Interconnect Cables, Panels, Racks, cabinets and enlosures
- BS Engineering
Summary:
Perform Mechanical Design and development associated with packaging electronic circuits including, assembly design, analysis, test, and manufacturing introduction support for both new and existing electronics design projects. Understand and mitigate possible failure mechanisms associated with materials, interconnects, and environmental loads to develop a reliable design. Assists in performing detailed design and component layout for new or improved subsystems. Assumes engineering responsibility for component and subassembly test development, data acquisition, analysis, and reporting. Performs tolerance analysis at system and subsystem level.
Perform Mechanical Design and development associated with packaging electronic circuits including, assembly design, analysis, test, and manufacturing introduction support for both new and existing electronics design projects. Understand and mitigate possible failure mechanisms associated with materials, interconnects, and environmental loads to develop a reliable design. Assists in performing detailed design and component layout for new or improved subsystems. Assumes engineering responsibility for component and subassembly test development, data acquisition, analysis, and reporting. Performs tolerance analysis at system and subsystem level.
- Ability to design and document all aspects of the electrical infrastructure including:
- AC, DC, Main power distribution (panel boards, boxes and cabinets)
- Interconnect cables, bundles and connectors (harnessing)
- Electronic racks, cabinets, control consoles
- Interfacing with printed circuit board designs
- Modeling of flex and rigid PWB's including volumes and critical part locations
- Experience designing electronic enclosure assemblies
- Experience in sheet metal design
