About the Position: This position is located at US ARMY AVIATION AND MISSILE COMMAND, USATA, TMDE SPT REGION WEST, OFFICE OF THE DIRECTOR, FT CARSON.Qualifications: Who May Apply: Only applicants who meet one of the employment authority categories below are eligible to apply for this job. You will be asked to identify which category or categories you meet, and to provide documents which prove you meet the category or categories you selected. See Proof of Eligibility for an extensive list of document requirements for all employment authorities.
- 30 Percent or More Disabled Veterans
- Current Department of Army Civilian Employees
- Current Department of Defense (DOD) Civilian Employee (non-Army)
- Domestic Defense Industrial Base/Major Range and Test Facilities Base Civilian Personnel Workforce
- Interagency Career Transition Assistance Plan
- Land Management Workforce Flexibility Act
- Military Spouses, under Executive Order (E.O.) 13473
- Non-Department of Defense (DoD) Transfer
- Office of Personnel Management (OPM) Interchange Agreement Eligible
- People with Disabilities, Schedule A
- Priority Placement Program, DoD Military Spouse Preference (MSP) Eligible
- Reinstatement
- Veterans Employment Opportunity Act (VEOA) of 1998
- Veterans Recruitment Appointment (VRA)
Experience refers to paid and unpaid experience, including volunteer work done through National Service programs (e.g., Peace Corps, AmeriCorps) and other organizations (e.g., professional; philanthropic; religious; spiritual; community; student; social). You will receive credit for all qualifying experience, including volunteer experience.
There is no specific length of training or experience required. However, you must be able to demonstrate, through experience shown in your written application materials that you possess the sufficient knowledge, skills, and abilities to successfully perform the work of this position without more than normal supervision.
Minimum Qualifications (Screen Out Element): Ability to do the work of an Precision Measurement Equipment Calibrator without more than normal supervision. I am able to perform common Precision Measurement Equipment Calibrator tasks including calibration and repair operations on Precision Measurement Equipment; interpreting technical procedures and schematics and adapt them to calibration assignments; applying troubleshooting techniques to diagnose and repair test, measurement, and diagnostic equipment (TMDE) upon completion to make sure they are properly performed. - Failure to meet this Screen Out Element will result in an ineligible rating.
- Ability To Do The Work Of The Position Without More Than Normal Supervision
- Ability to Interpret Instructions, Specification, etc. (includes blueprint reading)
- Ability To Use and Maintain Tools and Equipment
- Knowledge of Equipment Assembly, Installation, Repair, etc.
- Technical Practices (theoretical, precise, artistic)
- Theory and Instruments (Electrical Electronic) Used in Shop and Trade Practices
- Trouble Shooting
- PHYSICAL EFFORTS: The work may require long periods of standing or sitting along with some walking or bending during the course of extended periods on measurements. Requires frequent lifting, carrying, and handling of items weighing up to 40 pounds with occasional requirements to lift items in excess of 50 pounds.
- WORKING CONDITIONS: The work is performed in laboratories and user facilities where technicians are exposed to the hazards of high voltage high pressure, high and low temperatures, chemicals and radiation. Calibrators must comply with all safety regulations applicable to the calibration mission.