Address
Form of workTitle: Senior Electrical Engineer - Electronic Product Development Support
Location: Santa Clara, CA (On-site)
Client: Quest Global/Client
Salary/Rate:$130-140k/year or $70-80/hour C2C
Required Skills: (Medical domain is a must)
Job Profile:
Preferred qualification
Location: Santa Clara, CA (On-site)
Client: Quest Global/Client
Salary/Rate:$130-140k/year or $70-80/hour C2C
Required Skills: (Medical domain is a must)
Job Profile:
- The primary job will be to support customer for their Electronic Product Engineering Activities and act as an Onsite-offshore co-Ordinator. The candidate shall also be self-driven to learn and adapt to new technologies & methodologies as the industry needs.
- Domain Specific Skills
Preferred qualification
- Bachelor of Electrical / Electrical & Electronics Engineering/Electronics and Instrumentation/Communications Engineering
- Years of Experience [ Relevant] : 10 to 15 Years
- Design & Development of embedded electronics devices and assemblies.
- Collaborating with firmware, mechanical, testing and production teams.
- Resolving EMC/EMI issues and ensure timely release of product.
- Analyze the System Level Requirements and create an Architecture Design.
- Root cause analysis of Field return devices.
- Analyze Reliability issues and implement design changes and perform board level testing.
- Board and system level Verification and Validation.
- Review the Technical artifacts generated by customer as well as offshore team.
- Pre compliance testing (EMC/EMI).
- Offshore co-ordination and Customer Engagement.
- Complete Hardware design lifecycle including compliance testing and certification.
- Design and development of Analog, Digital circuits.
- Discrete circuits building with OPAMP, Mosfet, Transistors, Client, DAC, Isolators, High side load switches.
- Microcontrollers, FPGA, DDR4, DDR3 SDRAM, SRAM, Flash Memory and EEPROM.
- High-speed designs USB, I2C, SPI, UART, RS232, RS422/485 communication interfaces.
- MTBF, DFMEA.
- Good knowledge of manufacturing / prototyping process.
- Schematic Design and PCB Layout review.
- Technical Documentation and V&V report generation.
- Knowledge in Regulatory Standards, EMI/EMC/ENV/UL/Reliability standards.
- Knowledge in Medical device Product Standards- IEC60601-1, Medical device Product development lifecycle process & documentation.
- Proficient in safely using most of the lab equipment used for Electronic Product Development: Oscilloscopes, Logic analyzer, electronic loads, signal generators etc.
- OrCAD Capture ( Circuit design – Schematics)
- Siemens (Mentor Graphics) PADS Layout
