Address
Form of workDescription
Flanders is looking for an AC/DC Mechanic with strong safety orientation and attention to detail for our team in Longview, TX! The selected candidate will play a key role within a team that will work together to build components of and repair AC/DC motors.
Here's What You'll Do:
Requirements
Requirements:
• Education: High school diploma or equivalent.
• Experience: Three years mechanic experience.
Values Statement: Cares for people; shows humility; acts with absolute integrity and trustworthiness; never gives up; continually grows; and demonstrates excellence.
Flanders is looking for an AC/DC Mechanic with strong safety orientation and attention to detail for our team in Longview, TX! The selected candidate will play a key role within a team that will work together to build components of and repair AC/DC motors.
Here's What You'll Do:
- Essential Functions: Perform under supervision.
• Preparation: Read work scope to determine job status, work authorizations/limitations, description of problems, and/or expected serviceability
• Disassembly: Disassemble basic and routine electromechanical equipment noting parts identification, configuration, and condition. Properly mark parts, take photos, and thoroughly complete paperwork to ensure accurate job completion that meet company and ISO standards.
• Assembly: Assemble basic and routine motors and equipment including ball and roller bearings. Pretest electrical, mechanical, and ensure proper lubrication per customer standards.
• Testing - Learning to perform basic test of electromechanical equipment and document accordingly. Troubleshoot known or suspected problems. Operate Megger, AC/DC Hypot, Surge
Tester, Volt-Ohm Meter, and Feeler Gauges as needed on jobs. Read and draw diagrams of motors and parts.
• Clean & Inspect - Learning to clean electromechanical equipment assemblies as needed using various methods and steps including but not limited to parts washers/steamers, etc. Thoroughly inspect parts for wear and damage and record any worn or damaged parts.
• Parts Flow Process - Measure for and note proper replacement parts. Requisition needed items as approved by foreman. Store parts accurately according to job status or work scope after the dismantling process. Ensure ISO standards are met for storage.
• Repairs - Repair or replace defective mechanical or electromechanical parts including but not limited to bearings, brushes, brush holders, motor leads, gears, seals, impellers, mechanical switches, brakes, clutches, clutch rotors, tachs, fans, couplings, and end shields.
o Under supervision, lift, tighten, adjust, and/or secure heavy objects in order to perform work duties.
o Maintain thorough paperwork throughout entire repair process including all test sheets from receiving unit description to Quality Control Checklist. Record accurately and on a timely basis. - Work in a timely manner to ensure customer needs are fulfilled and deadlines are met. Work at a pace that meets expected productivity goals.
- Operate various pieces of equipment including a buffer, air tools, hand and foot shear, fork lifts and cranes.
Requirements
Requirements:
• Education: High school diploma or equivalent.
• Experience: Three years mechanic experience.
- Ability to perform basic math functions including addition, subtraction, multiplication, division, fractions, and percentages.
- Ability to read, write, and comprehend simple to moderately complex written and verbal instructions.
- Ability to understand, perform, and retain various job related training, operational, and safety procedures.
- Ability to operate fork lift trucks, and other equipment.
- Ability to receive respirator clearance.
- Ability to read tape measures, dial calipers, and micrometers.
Values Statement: Cares for people; shows humility; acts with absolute integrity and trustworthiness; never gives up; continually grows; and demonstrates excellence.
