Job Description
Pay: $24/hour (Includes Shift differential)
2nd Shift
2pm-10:30pm
Responsible for multi machine operation experience including Gallus printing presses, label applicator, blister machine etc. Pallet jack or forklift experience are a must. Ensure product assembly meets production requirements (both quality and quantity) Proper identification and physical movement of raw, in-process and finished goods materials to and from storage locations, Ability to lift and manipulate heavy equipment.
Main Operator (front of the press)
Area: Rotary punches to sheeter
Job description
Set up:
- Set up correct dies in correct stations.
- Change webbing to incorporate correct rotary punch (if needed) -Begin to set up current job.
- Splice on proper R.M if needed/align
- Begin at first ink station, set impression.
- Continue to next needed ink stations-#4 -Set impression and registration sensor.
- Engage HM, set impression, reg. sensor, put in register.
- Remove web from rewind send through sheeter into Gannicott.
- Pull trim.
- Start aligning sheeter first, next station 1 ,2, 3 and rotary punch.
- Fine tune product 250 fpm.
- Pull a good stack & NDC for startup.
- Fill out paperwork.
RUN
- Continuously check and ensure machine and product are properly running.
- Walk up and down press, double check R.M hung proper, check inks, monitor H.M, look and listen to machine.
- Check product registration OFTEN (this is the main responsibility of operator
- “Assist packager” if needed, help stock packaging supplies if running low, if the times permits it.
- Clean and wipe down machine and area.
- Pull a stack for retains, perform all quality checks needed.
- Ensure Gannicott is running smooth, and stacks are proper.
- Clean and wipe again machine.
TEARDOWN
Main operator: should have the paperwork and retains done, end of job procedures, perform the final.
In charge of changing the dies and the hole punches.
- Pull a good tack and NDC for final.
- Fill out all paperwork.
- Complete and close the job.
- Remove dies from station.
- Remove and purge all previous job from area.